아두이노 프로미니 신호 제너레이터 쉴드 (SparkFun MiniGen - Pro Mini Signal Generator Shield) / 프로 미니
판매가격 : 39,600원 (부가세 포함)
상품코드 :[4812]WAD-DAV2-ZAS
배송일 :당일발송
제조사 :Sparkfun
브랜드 :SparkFun [브랜드몰 바로가기]
남은수량 : 3개
구매수량 :
총 금액 :
추가&대량구매 요청 053-588-4080

  • 상품상세
  • 관련상품
  • 배송/교환/반품 안내
  • 상품리뷰
아두이노 프로 미니에 사용될 수 있으며, Sine, Square, Triangle 등의 신호 파형을 최대 3MHz까지 만들어서 보낼 수 있습니다.

특징 (Features) :

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)


다운로드 자료 (Materials) :

Description: This is the SparkFun MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

Features:

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

Documents:

Image Map 메카리워즈






견적요청
구매대행
퀵/방문수령
후불결제
기술문의