CUhead Pro는 와이파이/이더넷을 사용해서 안드로이드 혹은 iOS에서 오디오 장치를 컨트롤 할 수 있도록 도와줍니다.
Description: This is the CUhead Pro, a WiFi/Ethernet Arduino shield with Airplay and DLNA audio and also acts as an access point for WiFi devices. It also makes julienne fries! Alright, that last one may have been a stretch but with this shield you WILL be able to wirelessly push music and other sounds from your iOS and Android device and more. With very minimal work and programming you can have this versatile little guy up and running in no time. As the CUhead Pro is a shield, simply plug it into your Arduino based dev board and start transmitting.
The CUhead Pro is equipped with USB-A port, RJ45 ethernet port (just in case there isn’t a WiFi signal), and a 3.5mm audio jack. It is important to note that on this shield the USB host is reversed for future firmware updates. An interesting feature about the CUhead Pro is the detachable WiFi module with an RT5350 SoC chip from Ralink. The RT5350 SoC combines Ralink’s IEEE 802.11n draft compliant 1T1R MAC/BBP/PA/RF, a high performance 360 MHz MIPS24KEc CPU core, a 5-port integrated 10/100 Ethernet switch/PHY and a USB host/device.
Note: LinkSprite has completed working on OpenWRT support! Check the link in the Documents section below for more information.