상품카테고리 > 센서

HX711 로드셀 측정 컨버터 모듈 (SparkFun Load Cell Amplifier - HX711)
판매가격 : 13,200원 (부가세 포함)
상품코드 :[3337]LSH-SP-13879
배송일 :당일발송
제조사 :Sparkfun
브랜드 :SparkFun [브랜드몰 바로가기]
남은수량 : 9개
구매수량 :
총 금액 :
추가&대량구매 요청 053-588-4080

  • 상품상세
  • 관련상품
  • 배송/교환/반품 안내
  • 상품리뷰
HX711이라는 칩을 사용하여 로드셀을 사용할 수 있습니다. 
24 비트 ADC를 사용하기 때문에 보다 정밀하게 센싱을 할 수 있으며, 로드셀 뿐만 아니라 압력 등 정밀하게 증폭을 해야하는 애플리케이션에 사용될 수 있습니다.




Description: The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connecting the amplifier to your microcontroller you will be able to read the changes in the resistance of the load cell, and with some calibration you’ll be able to get very accurate weight measurements. This can be handy for creating your own industrial scale, process control or simple presence detection.

This version of the SparkFun Load Cell Amplifier features a few changes that you specifically asked for! We have separated the analog and digital supply, as well as added a 3.3uH inductor and a 0.1uF filter capacitor for digital supply.

The HX711 uses a two-wire interface (Clock and Data) for communication. Any microcontroller’s GPIO pins should work, and numerous libraries have been written, making it easy to read data from the HX711. Check the hookup guide below for more information.

Load cells use a four-wire Wheatstone bridge configuration to connect to the HX711. These are commonly colored RED, BLK, WHT, GRN and YLW. Each color corresponds to the conventional color coding of load cells:

  • Red (Excitation+ or VCC)
  • Black (Excitation- or GND)
  • White (Amplifier+, Signal+ or Output+)
  • Green (A-, S- or O-)
  • Yellow (Shield)

The YLW pin acts as an optional input that is not hooked up to the strain gauge but is utilized to ground and shield against outside EMI (electromagnetic interference). Please keep in mind that some load cells might have slight variations in color coding.

Note: Special thanks to Bodge for supplying the Library for the HX711!

Features:

  • Operation Voltage: 2.7V–5V
  • Operation Current: < 1.5mA
  • Selectable 10SPS or 80SPS output data rate
  • Simultaneous 50 and 60Hz supply rejection

Documents:



Image Map 메카리워즈












견적요청
구매대행
퀵/방문수령
후불결제
기술문의