Dfrobot에서 만든 5V 16MHz의 아두이노 프로미니 호환보드입니다. 일반적인 아두이노 프로미니와 같은 기능을 하며, FTDI를 사용하여 프로그램을 업로드 할 수 있습니다. INTRODUCTION
The 5V DFduino Pro Mini V1.3(Arduino Pro Mini Compatible)
is a microcontroller board based on the ATmega328.It is a 5V DFduino
running the 16MHz bootloader (select 'Arduino Duemilanove w/ 328' within the
Arduino software).
It is an advance version of offical Arduino Pro Mini. The
DFRduino Pro mini has 8 analog inputs compared with offical 6. The rest
bits are exactly the same.
It has 14 digital input/output pins (of which 6 can be
used as PWM outputs), 8 analog inputs, an on-board resonator, a reset button,
and holes for mounting pin headers. A six pin header can be connected to an
FTDI cable or DFRobot breakout board to provide USB power and communication to
the board.
The DFRduino Pro Mini is intended for semi-permanent
installation in objects or exhibitions. The board comes without pre-mounted
headers, allowing the use of various types of connectors or direct soldering of
wires. The pin layout is compatible with the Arduino Mini.
We recommand that you choose one of following items to
program and supply power for your Mini pro board.
1. FTDI Basic
Breakout 3.3/5V (Arduino Compatible)
2. USB Serial Light
Adapter (Arduino Compatible)
Note: Compared with DFduino Pro Mini V1.2, this V1.3
reverses the pins of the programming interface.
SPECIFICATION
·
DC input 5V up to
8V(power supply from RAW pin)
·
DC input 5v(from
VCC pin)
·
Bootloader:
Arduino Pro/Pro Mini (5V, 16Mhz) w/ Atmega328
·
5V regulator
·
Max 150mA output
·
ATmega328 running
at 16MHz with external resonator (0.5% tolerance)
·
Low-voltage board
needs no interfacing circuitry for popular 3.3V devices and modules (GPS,
accelerometers, sensors, etc)
·
USB connection off
board
·
Supports
auto-reset
·
Over current
protected
·
Reverse polarity
protected
·
On board Power and
Status LEDs
·
Size:0.7x1.3"
(18x33mm)
DOCUMENTS
·
Schematic
·
LDO
regulator datasheet
·
Getting Started Tutorial
SHIPPING LIST
·
DFRduino Pro Mini
V1.3 x1
|
