상품카테고리 > 전자 부품 > 센서보드 > 생체센서

Gravity 아날로그 심장박동 모니터링 센서 / Gravity: Analog Heart Rate Monitor Sensor (ECG) For Arduino
판매가격 : 28,600원 (부가세 포함)
상품코드 :[6005]ZAS-DFR-SEN0213
배송일 :당일발송
제조사 :DFRobot
브랜드 :DFRobot [브랜드몰 바로가기]
남은수량 : 2개
구매수량 :
총 금액 :
추가&대량구매 요청 053-588-4080

  • 상품상세
  • 관련상품
  • 배송/교환/반품 안내
  • 상품리뷰

DFrobot사의 심장박동 모니터링 센서입니다. 심장박동을 그래프로 확인해볼 수 있습니다. 사용방법 및 자세한 스펙은 하단부의

Wiki를 참고해주세요.





INTRODUCTION

The DFRobot Heart Rate Monitor Sensor is used to measure the electrical activity of the heart. This electrical activity can be charted as an ECG and output as an analog reading. An ECG signal can be extremely noisy so we have included an AD8232 chip which will generate a clear signal from the PR and QT Intervals. Using the Arduino IDE "Serial Plotter" feature,  you are also able to view plotted ECG output on  PC!
 

via GIPHY


To ease the difficult of using this sensor,  a Gravity Interface is adapted to allow plug&play.  The IO expansion shield is the best match for this sound senor connecting to your Arduino. As this sensor can work at 3.3V which make it compatible with Raspberry Piintel edison, joule and curie. 

NOTE: This product is NOT a medical device and is not intended to be used as such or as an accessory to such nor diagnose or treat any conditions.

SPECIFICATION

  • Input Voltage: 3.3-6V (5V recommended)
  • Output Voltage: 0-3.3V
  • Interface: Analog
  • Operating current: <10mA
  • imension: 35 x 22(mm), 1.378" x 0.866"(in)
  • Interface Type: PH2.0-3P

DOCUMENTS

SHIPPING LIST

  • Heart Rate Monitor Sensor x1
  • Sensor cable - Electrode Pads (3 connector) x1
  • Biomedical Sensor Pad x6
  • PH2.0-3P cable x1

메카리워즈






견적요청
구매대행
퀵/방문수령
후불결제
기술문의