10 ~ 20m 정도의 통신 거리를 가지고 최대 2.0Mbps 의 data
3.3V ~ 5V에서 동작이 가능합니다.
Using the miniature Roving Network / Microchip RN42 Bluetooth 2 Module, easily lets you communicate wirelessly with your TinyDuino via a standard serial port from your computer using Bluetooth SPP (Serial Port Profile Mode). Once connected, this works just like you are connected using USB to your TinyDuino, except now without the wire, since the entire Bluetooth stack software is completely contained in the module, there is no programming required.
This TinyShield is great for short range communications (10 – 20 meters) between your PC / Phone and the Bluetooth module and can support high data rates of up to 2.0Mbps over the air.
Includes power supply and level shifters on the board, so you can run your TinyDuino from 3.3V – 5V.
Note: Apple iPhones / iPad users should use the Bluetooth Low Energy Shield instead due to Apple licensing restrictions.
Fully certified Class 2 Bluetooth 2.1 + EDR module
Bluetooth SIG qualified
UART (SPP or HCI) and USB (HCI only) data connection hardware interfaces
Onboard embedded Bluetooth stack (no host processor required)
Programmable low power modes
Secure communications, 128 bit encryption
Error correction for guaranteed packet delivery
UART local and over-the-air RF configuration
Auto-discovery/pairing requires no software configuration (instant cable replacement)
Ultra compact size and weight
Rectangular Version: 20mm x 36mm (.787 inches x 1.417 inches)
Max Height (from lower bottom TinyShield Connector to upper top TinyShield Connector): 5.11mm (0.201 inches)
Weight: TBD grams (TBD ounces)
UART Mode used
Arduino pins 0 – 1 used by this shield (the standard hardware UART lines)
Built in level shifters and linear power supply to allow your TinyDuino to run up to 5.0V operation.