마이크로 SD 리더 모듈, MicroSD 카드 브레이크아웃보드 (MicroSD card breakout board+)
판매가격 : 18,700원 (부가세 포함)
상품코드 :[3872]DAV-ZAS
배송일 :당일발송
제조사 :Adafruit
브랜드 :Adafruit [브랜드몰 바로가기]
남은수량 : 3개
구매수량 :
총 금액 :
추가&대량구매 요청 053-588-4080

  • 상품상세
  • 관련상품
  • 배송/교환/반품 안내
  • 상품리뷰
마이크로 SD 카드 슬롯이 부착되어있는 브레이크아웃보드 (모듈) 입니다. 아두이노등의 제어보드에 사용하여 
저장공간을 만들 수 있습니다.

  • DESCRIPTION

Not just a simple breakout board, this microSD adapter goes the extra mile - designed for ease of use.

 

  • Onboard 5v->3v regulator provides 150mA for power-hungry cards
  • 3v level shifting means you can use this with ease on either 3v or 5v systems
  • Uses a proper level shifting chip, not resistors: less problems, and faster read/write access
  • Use 3 or 4 digital pins to read and write 2Gb+ of storage!
  • Activity LED lights up when the SD card is being read or written
  • Four #2 mounting holes
  • Push-push socket with card slightly over the edge of the PCB so its easy to insert and remove
  • Comes with 0.1" header (unattached) so you can get it on a breadboard or use wires - your choice
  • Tested and assembled here at the Adafruit factory
  • Works great with Arduino, with tons of example code and wiring diagrams

To use with an Arduino, connect GND to ground, 5V to 5V, CLK to pin 13, DO to pin 12, DI to pin 11, and CS to pin 10. Then you can use the wonderful SDfatLib which supports FAT and FAT32 SD cards. For details on getting started, check out our detailed tutorial discusses microSD cards, wiring and how to use this breakout board with an Arduino

  • TECHNICAL DETAILS

Dimensions (without 0.1" header):

·         Length:31.85mm/1.25in

·         Width:25.4mm/1.00in

·         Height:3.75mm/0.15in

·         Weight:3.43g/0.12oz

 

메카리워즈






견적요청
구매대행
퀵/방문수령
후불결제
기술문의